Installer Setup; Installer Test; Operating Your Thermostat - Honeywell T6811DP08 Instrucciones De Instalación

Installer Setup

1. Press and hold UP and MODE buttons simultaneously
for 3 seconds to enter the Installer Setup mode.
2. Press UP or DOWN button to change settings.
3. Press MODE button to advance to the next function.
4. Press and hold UP and MODE buttons simultaneously
for 3 seconds to exit and save settings.
No. Description
1 System Type
9 Temperature Scale
13 CPH value For Heat
14 CPH value For Cool
18 Display Temperature
adjustment
19 Temperature Display
mode
20 Heating Range Stops 10–32°C Default 32°C
21 Cooling Range Stops 10–32°C Default 10°C
22 Keypad Lockout

Installer Test

1. Press and hold UP and DOWN buttons simultaneously
for 3 seconds to enter the Installer Test mode.
2. Press UP or DOWN button to change settings.
3. Press MODE button to advance to the next function.
4. Press and hold UP and MODE buttons simultaneously
for 3 seconds to exit and save settings.
Possible Options
0 Heat only
1 Cool only
2 Two pipes 1H1C manual
(Default)
0 °F
0 °C (Default)
1–12
4 (Default)
1–6
3 (Default)
-2°C (-4°F)
-1.5°C (-3°F)
-1°C (-2°F)
-0.5°C (-1°F)
0°C (0°F) (Default)
0.5°C (1°F)
1°C (2°F)
1.5°C (3°F)
2°C (4°F)
0 Display Room
Temperature (Default)
1 Display Setpoint
(50–90°F) Default 90°F
(50–90°F) Default 50°F
0 All keys available (Default)
1 All keys locked out
T6811DP08/T6812DP08 DIGITAL THERMOSTAT
No. Description
10 Installer Test Heat
30 Installer Test Cool
70 Press UP button to see software info (71, 72 & 73)
71 Software version (Major)
72 Software version (Minor)
73 Identification code

Operating Your Thermostat

1. Power On/Off
Slide the POWER switch thermostat will enter the On/Off
mode.
2. Fan Switch
Slide the FAN switch to select Fan mode
High.
3. System Mode Setting
Press the MODE button to choose
Vent. In ventilation mode, only the fan will operate.
4. Temperature Setting
In Heat/Cool mode, press the  or  (UP or DOWN button)
to select the desired temperature setting.
Table 1. Troubleshoting Tips.
If...
Heating • Set the mode to Heat
system does Mode button.
not turn on • Check that the heat temperature setting is
above the room temperature.
• Check heating on icon
the display.
• Wait five mintues for the heating system
to respond.
Cooling • Set the mode to Cool
system does Mode button.
not turn on. • Check that the cool temperature setting is
below the room temperature.
• Check cooling on icon
the display.
• Wait five mintues for the cooling system to
respond.
The Mode • Check whether the keypad is locked or
button doesn't not.
work. • Check whether the thermostat is off.
The Up or • Check whether the keypad is locked or
Down button not.
doesn't work. • Check whether the system is working
Ventilation mode.
• Check whether the thermostat is off.
3
Possible Options
0 Heat Off
1 Heat On
0 Cool Off
1 Cool On
Low, Med,
Heat, Cool or
Then...
by pressing the
shows solidly in
by pressing the
shows solidly in
62-0325ES—01