Installer Setup - Honeywell PRO TH1000 Serie Guia De Instalacion

Installer setup

Follow the procedure below to personalize and
configure the thermostat according to the heating/
cooling system.
Press and
will appear as shown on the right.
Press or
Press and
the next function.
Press Run to exit the menu and save any
changes.
NOTE: You will also exit the menu if you press
for three seconds when the last function is
displayed.
Function
1 Temperature display format
2
Time display format
3 Heating cycles per hour
4 Cooling cycles per hour
5
Compressor protection
6
Adaptive Intelligent Recovery
1
Applicable to programmable models (TH2110D & TH2210D) only.
2
Damage can occur if the compressor is restarted too soon after shutdown. This feature
forces the compressor to wait 5 minutes before restarting. During the wait time, the
message Cool On or Heat On flashes on the screen. When the safe wait time has elapsed,
the message stops flashing and the compressor turns on.
3
Applicable to programmable models (TH2110D & TH2210D) only.
Adaptive Intelligent Recovery™ allows the thermostat to "learn" how long your furnace or
air conditioner takes to reach the set temperature. Simply program the desired times and
desired temperatures into the schedule. The thermostat will determine when to activate
heating or cooling so that the desired temperature is attained at the desired time.
for three seconds. The display
to change the option.
for three seconds to advance to
Default
setting
0
1
0
5
3
2
0
3
1
and
0: Fahrenheit
1: Celsius
0: 12-hour display
1: 24-hour display
2 to 6 cycles per hour
• 2: 30 min (steam, gravity)
• 3: 20 min (hot water, 90%+ high-efficiency furnace)
• 4: 15 min (gas or oil)
• 5: 12 min (gas or oil)
• 6: 10 min (electric)
2 to 6 cycles per hour
0: enabled (for systems without a compressor))
1: disabled (for systems equipped with a compressor)
0: Off
1: On
5
PRO TH1000 / TH2000 Series
Function
number
Option
number
Options