Installer Setup; Factory Default - Honeywell FocusPRO TH5000 Serie Guia De Instalacion

Installation Guide

Installer setup

Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes.
Setup function
Shaded areas below apply only to
1 System type
2 Changeover valve er valve er valve
(O/B terminal) minal minal)
3 Fan control control trol
(heating) eating)
5 Stage 1 heat cycle Stage 1 heat cycle Stage 1 heat cycle
rate (CPH: cycles/hou rate (CPH: cycles/hou rate (CPH: cycles/hour)*
6 Stage 2 heat Stage 2 heat cycle
rate/Auxiliary heat te/Auxili
cycle rate (CPH)*
7 Auxiliary heat cycle
rate (CPH)*
Only TH5320U
for 3H/2C Heat Pumps
8 Emergency heat cycle
rate (CPH)*
*[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
Function
number
Done
Press
Press NEXT to advance to the next function.
and FAN
Press DONE to exit and save settings.
Settings & options (factory default in bold)

factory default

TH5320U/TH5220D
0 1 heat/1 cool conventional ool conventional ol c
1 1 heat/1 cool heat pump (no aux. heat) cool heat pump (no aux. hea heat pump (no aux. hea
2 Heat only — 2-wire systems, 3-wire zone valves (Series 20), and nly — 2-wire systems, 3-wire y — 2-wire systems, 3-w
normally open zone valves mally open zone valves mally open zone valv
3 Heat only with fan eat only with fan at only with fan
4 Cool only Cool only ool
5 2 heat/1 cool heat pump (with aux. heat) heat/1 cool heat p
6 2 heat/2 cool conventional heat/2 cool conven
7 7 2 heat/1 cool conve 2 heat/1 cool conventional
8 8 1 heat/2 cool conventional t/2 cool conv
9 2 heat/2 cool heat pump (no aux. heat) - 2 heat/2 coo
10 10 3 heat/2 3 heat/2 cool heat pump (with aux. heat) -
0 0 Change Changeover valve (O/B terminal energized in cooling) hang
1 1 Chan Changeover valve (O/B terminal energized in heating) Chan
0 0 0 Gas or oil furnace — equipment controls fan in heating G
1 1 1 Electric furnace — thermostat controls fan in heating
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
Setting
1
0 0
Next Next
or to change settings. to change settings. to change settings.
XT to advance to t XT to advance to the next
DONE to exit and save set DONE to exit and save s
or as otherwise noted. r as otherwise n
TH5320U only
TH5320U only