Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Customize thermostat (installer setup)
Follow the steps below to begin installer setup. At each function screen,
▲
▼
press
or
to change the setting as desired, then press
the next function screen.
See tables on pages 4-6 for a description of options for each function.
FAN
To begin, press and hold the
until the display changes (about 3 seconds).
Function
Setting
1
Done
Back
Press DONE to save & exit.
Thermostat error codes
If E1 appears during setup, check error code number (right side of screen):
29
You are attempting to connect a thermostat to an incompatible device.
30
Zone number must match zone panel number (must be zero for EIM systems).
31
Verify that this zone number is configured at the zone panel as an RF thermostat.
33
Faulty return air sensor. Check wiring or replace sensor as needed.
34
Low signal strength. Move wireless device to a different location and try again.
38
Make sure Connected light is flashing and you are 2+ feet away from EIM or
wireless adapter.
Español: vea la página 9 • Français : voir la page 17
and ▲ buttons
FAN
0
Next
0
Done
Press ▲ or ▼ to change setting
(see tables on pages 4-6)
Press
NEXT
function screen
3
to advance to
NEXT
1
Back
to display next
Next
Publicidad
Tabla de contenido
