Oase Bitron Gravity 55 W Instrucciones De Uso página 16

- GB -
How to proceed:
C
• The screws and wall plugs required for fitting the wall brackets (5) can be purchased from a specialist store. The
type of screws and wall plugs to be used depends on the weight of the load to be supported and the surface to
which the wall bracket is to be fitted. The weight to be supported, i.e. the weight of the unit when filled with water is
approx. 17 kg.
• Mark the positions for the screws on the surface to which the wall brackets are to be fitted.
• Drill the holes for the wall brackets.
• Attach the wall brackets to the surface using suitable screws and wall plugs.
• Fit the unit to the wall brackets using the nuts and bolts from the accessory kit (10).
Fitting connections
D
A DN 110 pipe or connection set (10) (optionally available) can be fitted to the unit via the quick-release coupling
DN 110 (3). The connection set is used for the transition from a DN 110 connection to a 1 1/2" or 2" connection.
Note!
• The DN 110 quick-release coupling is only suitable for radial sealing of the connection against the pressure
of the water.
• Pipes and hoses also have to be axially protected in a suitable way.
• Use pipes and hoses that are suitable for a pressure of at least 1 bar.
• Never close any valves when the pump is operating.
To connect a DN 110 pipe, proceed as follows:
• Release the DN 110 quick-release coupling (3) by loosening the hexagon screws.
• Push the DN 110 quick-release coupling onto the top or bottom socket of the unit until the socket makes light con-
tact with the centre rubber lip (21).
• Insert the DN 110 pipe into the quick-release coupling until it also makes light contact with the centre rubber lip (21).
• Fix the DN 110 quick-release coupling in place by tightening the screws.
• Check that all the screws are firmly seated.
To connect a 2" or 1 1/2" hose, proceed as follows:
• Release the DN 110 quick-release coupling by loosening the hexagon screws.
• Push the DN 110 quick-release coupling onto the top or bottom outlet socket of the unit until the socket makes light
contact with the centre rubber lip (21).
• Insert the connection adapter from the connection set (10, not included in the delivery scope) into the quick-release
coupling until it also makes light contact with the centre rubber lip (21).
• Fix the DN 110 quick-release coupling in place by tightening the screws.
• Select a hose connector from the connection set that is suitable for the hose used and fasten it to the connection
adapter with the sealing ring inserted.
• Fit the hose onto the hose connector and secure with a hose clip.
• Check that all the screws are firmly seated.
Installing the Bitron Gravity in the ProfiClear Premium Individual module
Note!
• It is necessary to shut down the ProfiClear Premium filter system before installing the Bitron Gravity in the
Individual Module. Refer to the respective instructions for shutting down and starting up the system.
Installing the Bitron Gravity in the container
A maximum of two Bitron Gravity UVC clarifying units can be installed in the container of an Individual Module. For this
purpose, each UVC clarifying unit must be equipped with a DN 110 quick-release coupling (3), a DN 110 pipe collar (4)
and a rubber foot (6).
The connection cables connected to the units can be fastened to the edge of the container using the supplied cable
clips and routed out of the container via the cable slot.
16