Installation And Connection - Oase Bitron Gravity 55 W Instrucciones De Uso

Correct electrical installation
• Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
• A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the
recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regu-
lations.
• For your own safety, please consult a qualified electrician.
• The unit may only be connected when the electrical data of the unit and the power supply coincide. The unit data is
to be found on the unit type plate or on the packaging, or in this manual.
• Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
• Extension cables and power distributors (e. g. outlet strips) must be suitable for outdoor use.
• Ensure that the power connection cable cross section is not smaller than that of the rubber sheath with the identifi-
cation H05RN-F. Extension cables must meet DIN VDE 0620.
• Protect the plug connections from moisture.
• Only plug the unit into a correctly fitted socket.
Safe operation
• Never operate the unit if either the electrical cables or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
• Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical modifications to the unit.
• The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
• Only operate the unit if no persons are in the water!
• Keep the socket and power plug dry.

Installation and connection

Set-up the unit
B, C
• The unit is installed outside the pond. It is protected from temporary flooding. Install the unit such that the unit head
remains predominantly dry.
• The unit can be mounted horizontally or vertically on a firm base. Ensure that there is sufficient space for performing
maintenance work such as e.g. replacing the UVC lamp.
• If several units are used, they can be interconnected.
• For installation below the level of the water, fit a slide valve in the water supply pipe so that the unit can be partially
or completely sealed off for controlling the flow or for performing maintenance work.
OASE recommends: Slide valve DN 110 (Order No. 27171).
• The unit is particularly suitable and equipped for installation in the container of the Individual Module of the OASE
filter system ProfiClear Premium.
- GB -
15