Description Of Controls; Controls And Adjustments; First Switch-On - CombiSteel SL Instrucciones De Funcionamiento

EN

5. DESCRIPTION OF CONTROLS

The control interface is different for the various models.
5.1 Electromechanical version
1. ON-OFF button.
2. Power ON indicator.
3. Indicator displaying machine temperature ready to wash.
4. Start cycle button.
5. Wash cycle ON indicator.
6. Select cycle button (only models with 50x50 rack).
7. Activate drain pump button (option).
8. Indicator displaying lack of salt (option).
5.2 Electronic version with LCD display
1. ON-OFF button (press 2 seconds for ON)
2. Programming menu access button (press 3 seconds).
3. Drain pump/Self-cleaning button and ESC function when programming.
4. LCD display.
5. Select cycles and up/increase (+) function button used in programming.
6. Enable cold rinse (option) and down/decrease (-) function button when programming.
7. Start cycle light and Enter function when programming.
When the machine is OFF, the message "OFF" appears on the display and the power indicator
8 is red.
36
60 "
V : 5 5 ° C B : 8 2 ° C
6. START-UP, FIRST SWITCH-ON
The user must have sufficient knowledge and
experience in order to read and understand
the information in this manual, interpret
the signs and symbols on the machine, and
carry out safety operations (e.g. turn off
the main switch if water leaks are detected
inside the technical compartment or in case
of malfunction causing abnormal noise).

6.1 Controls and adjustments

In setting up the dishwasher, carry out the
following checks:
- Make sure all the cover panels and safety
devices are fitted and efficient.
Internal view of tank
MAKE SURE THE OVERFLOW
AND THE PUMP FILTER
ARE PROPERLY FITTED
MAKE SURE THE SURFACE
FILTERS (OPTION)
ARE IN PLACE
Check the water connection and drain
connection (see paragraph 4.3).
- Check the electrical connections and that
the power supply matches that specified on
the data plate.
- Make sure there are not foreign objects
inside the washing chamber and tank.

6.2 First switch-on

Connect the power cable to the control
panel, activate it, and open the water
faucet. If present, the detergent and
rinse aid dosing system must be adjusted
according to the water hardness and the
type of detergent and rinse aid used.
The adjustment operation will be necessary
even if a water softening system is installed
on the feed line. The dishwashers leave the
factory with dispensers adjusted to half
flow rate. To adjust the flow rate of the
dispensers, use the adjustment screw as
shown in the figure:
Version with electromechanical controls
(standard rinse aid dispenser, optional
detergent dispenser)
Adjustable detergent
dispenser
Rinse aid dispenser at
0 ÷ 0,82 gr/sec
supply pressure (2 Bar)
0 ÷ 3 gr/cycle
37
EN