Cleaning Function - CombiSteel SL Instrucciones De Funcionamiento

EN
END CYCLE
At the end of the wash cycle, the START button blinks green until the door is
reopened, and the display shows the message "END CYCLE"
RED LED
ON-OFF BUTTON
To turn the machine off, press the ON-OFF button twice. The led will become red.
6.5 Electronic version with LCD display
Close the door and turn the machine on
by pressing the "ON/OFF" button (1) for 2
seconds, the LCD display (4) will light up
and indicate the water loading phase.
After filling, the detergent and rinse aid
dispensers inject the dose as established
by the parameters relevant to the set wash
cycle.
Exaggerating with quantities
creates excessive foam that
can cause the wash pump to
malfunction.
Once the pre-set level has been reached, the
tank and boiler are full, the boiler heating
element starts heating the water inside (7
yellow) and the relative temperature blinks
on the display. Once the set temperature
is reached, the boiler heating element is
deactivated, while the one in the tank
starts heating the water (7 yellow) and
the temperature blinks on the display. See
paragraph 6.4. Once the set temperature is
reached, the tank heating element is also
deactivated.
42
GREEN BLINKING
OFF
60 "
V : 5 5 ° C B : 8 2 ° C
The START button (7) turns green when the
minimum tank and boiler temperatures are
reached. The machine is now ready to carry
out a wash cycle. Open the door, insert the
rack with items to be washed, select the
wash cycle with the "select times button"
(5), press the "start cycle button" (7). The
"wash cycle On indicator" turns blue, and
the machine starts washing. The cycle ends
when the "wash cycle On indicator" (7)
blinks green and "END CYCLE" appears on
the display, hence it is possible to remove
the rack and to proceed with other cycles.
It is possible to activate the automatic cycle
start, to take action upon closing the door,
by setting the "Automatic Cycle" parameter
to the value "ON" from the programming
menu. The setting remains active until the
next change. Once the parameter is enabled
by pressing the "select times button" (5) for
two seconds it is deactivated or activated as
desired.
At the end of service, always drain the
water in the tank: open the door, remove
surface filters and the overflow pipe (if
present) and attend emptying.
Remove the plastic pump filter only after emptying.
If the machine is fitted with a drain pump (option), keep the "drain pump button" (3) pressed,
to empty the tank.

6.6 Cleaning function

At the end of the service, a final cleaning cycle can be activated manually. With the machine
switched on and door closed, press and hold the "drain pump button" (3) for 3 seconds.
The display will show "REMOVE OVERFLOW PIPE!" and "TANK DRAINING" and the button
7 turns purple. Open the door and remove the overflow pipe (if present). When the tank is
empty the display will show "SELF-CLEANING" and after a short pause the solenoid valve or
the rinse pump (PRS versions) will be activated for a set time, followed by draining. After the
draining time, the machine will go to OFF mode.
If the door is left open after pressing the "drain pump button" (3), the machine will only drain
the tank, and remains in standby for five minutes, after which it will go to OFF mode without
cleaning.
SELF-CLEANING
3
6.7 Cold rinse function (option)
A cold rinse can be carried out at the end of the full wash cycle; the function
is activated by pressing button 6 for 3 seconds and
At the end of the rinse cycle, after a pause, button 7 will turn light blue and the display will
show the message COLD RINSE.
COLD RINSE
EN
PURPLE
LED 9 (blue) will light up.
9
LIGHT BLUE
6
43