Important; Supplies Required; Pre-Installation Information - Bradley FL-2H Manual Del Usuario

FL-2H, FL-2L
Installation
Packing List
•
•
•
IS
T H •
E
S ID
U P

Supplies Required:

• (6) 3/8" wall anchors, bolts and 1" min. O.D. washers to mount main frame and bowl to wall (minimum pull-out rating of
1,000 lbs.)
• (2) #10 wall anchors (for optional mixing valve/bracket mounting)
• 1/2" Nominal copper tubing for hot/cold or tempered supply piping
• 1-1/2" NPT drain piping
• OPTIONAL: 110 volt GFCI protected electrical outlet for 100–120 VAC plug-in transformer (for Bradley Faucets)
• OPTIONAL: 240/208 or 277 volts for electric tankless water heater
2

IMPORTANT!

Read this entire installation manual to ensure proper installation.
When finished with the installation, file this manual with the owner or
maintenance department. Compliance and conformity to local codes
and ordinances is the responsibility of the installers.
Separate parts from packaging and make sure all parts are accounted
for before discarding any packaging material. If any parts are
missing, do not begin installation until you obtain the missing parts.
Make sure that all water supply lines have been flushed and then
completely turned off before beginning installation. Debris in supply
lines can cause valves to malfunction.
Turn OFF electrical power to the electrical outlets, then unplug all
electrical units prior to installation. Electrical power MUST remain off
until installation is complete. After installation is complete, turn on
the water supply first, then turn on the electrical power.
Hardware provided by installer must be appropriate for wall
construction. Wall anchors must have a minimum pull-out rating of
1,000 lbs.
Product warranties may be found under "Products" on our Web site
at bradleycorp.com.
2/15/2012
Bradley Corporation • 215-1512 Rev. G; ECM 11-08-011
Installation