Shock Sensor Programming - Mopar 82209702 Instrucciones Para La Instalación

Shock sensor setting: (EVS I Systems only)
(Ensure module is mounted before adjustment!)
The "Lite-touch" and "Full shock" sensor settings are always the first and
second options, respectively, in Option Bank 1. To change the shock
sensor setting, follow these steps:
A. Make sure the driver's window is rolled down.
B. Enter Option Learn Mode, Option Bank 1, as shown on page 10.
C. Go to option #1 for Lite-touch ( parking lights flash 1 time ).
D. Close all doors (wait for domelight to turn off).
E. Press the door trim "Unlock" switch to increase sensitivity and press the
door trim "Lock" switch to decrease sensitivity.
F. Test the shock sensor sensitivity (while in option learn mode) by
applying an impact with an open hand to the windshield. Caution -
make sure to remove articles of jewelry to avoid scratching or
breaking glass.
The parking lights will flash each time an impact is detected that is
greater than the current setting.
G. Once the desired Lite-touch sensitivity is achieved, open a door to
advance to the Full shock option by pressing the door trim "Lock" switch
or, if the vehicle's door lock feature is non-functional with the ignition
turned on, press the factory keyfob "Lock" button (parking lights flash 2
times). Repeat steps D through F to set Full shock sensitivity.
H. Open a door to continue with "To change the setting of an option" on
page 10 (if necessary).
11