GEA JX7227 Instrucciones De Instalación página 3

3
INSTALL THE ANTI-TIP BRACKET
A Draw a line on the cutout floor at the center of the
cutout, and extend the line
cabinet.
Fold or cut the front edge of the template, along the
B
front guide line. Place the template flush along the
front edge of the cutout floor, aligning the center
line of the template with the center line of the cutout
floor. Mark the centers of the two screw holes with
an awl or center punch for the anti-tip bracket
location as shown.
C Remove the template and drill two holes for the
anti-tip bracket.
Screws
Install the anti-tip bracket onto the cutout floor
D
using two round-head screws.
Installation Instructions
down the face of the
1 2 "
Cutout Floor
Anti-Tip Bracket
4
INSTALL MICROWAVE OVEN INTO
CABINET
Slide the microwave oven part way into the cabinet
A
opening.
B
Plug in the microwave oven.
Bottom Duct
Anti-Tip
Bracket
Bottom Bracket
C
The bottom bracket must be flat to the cutout
floor to engage correctly with the anti-tip bracket
as shown. Carefully slide the microwave oven
back, engaging the anti-tip bracket. Make sure the
power cord is not mashed or cut as you slide the
microwave into place.
Center the microwave oven within the
D
cutout opening.
Ensure the microwave oven is accurately centered.
E
Line up the center line on the cabinet with the
triangular hole on the front of the bottom duct.
Screws
Drill pilot holes through the positioning flange and
F
then install five round-head screws
at the front of the bottom duct as shown.
Screw Models
4 JX7227SFSS, JX7230SFSS
5 JX7227DFBB, JX7227DFWW,
JX7230DFBB, JX7230DFWW
3
Anti-Tip Assembly
Cutout Opening
Positioning
Flange