Nice TT2N Instrucciones Y Advertencias Para El Instalador página 4

3.1) Settings via transmitters
• This chapter describes the memorisation procedures in
Mode I, used to control a single automation with the 3
keys of the transmitters. Paragraph 4.2 describes the
memorisation procedures in Mode II, used to control an
automation with a single key, thus leaving the other keys
free for control of other automations.
• The key ■ corresponds to the central key of the trans-
mitters ERGO, PLANO and NICEWAY.
• All memorisation sequences are timed, which means
they must be completed within the set time limits.
• With transmitters that envisage several "groups", the
relative group to associate with the control unit must be
selected before proceeding.
When there is no transmitter memorised, the first can be memorised according to the following procedure.
Table "A1" Memorisation of first transmitter in Mode I
1. Connect the control unit to the power mains, confirmed by 2 long flashes.
Within 5 seconds press and hold key ■ of the transmitter to be memorised
2.
(for at least 3 seconds).
Release key ■ on the first of the three flashes confirming memorisation.
3.
If transmitters have already been memorised, others can be enabled as described in the following procedure.
Table "A2" Memorising other transmitters in Mode I
Press and hold key ■ of the new transmitter (for at least 5 seconds) confirmed by a
1.
long flash, after which release.
Slowly press key ■ three times of a previous and memorised transmitter.
2.
Press the key ■ of the new transmitter, and release on the first of the 3 long flashes
3.
confirming memorisation.
Note. If the memory is full (30 transmitters memorised) 6 long flashes are emitted and the transmitter cannot be memorised.
3.2) Settings via the programming pushbutton
To memorise a transmitter via the programming pushbutton proceed as described below.
Table "A3" Memorisation of a transmitter in Mode I
1. Press and hold the programming pushbutton (for at least 4 seconds).
2. Release the programming pushbutton when the led illuminates.
3. Within 10 seconds press any key of the transmitter to be memorised for at least
3 seconds.
4. If the memorisation procedure is successful, the led emits 3 long flashes.
Note. If there are other transmitters to be memorised, repeat point 3 within a further 10 seconds; the memorisation phase terminates if no
new transmitters are received within a 10 second interval.
If memorised transmitters and settings need to be deleted, proceed as described below.
Table "A4" Deleting items from the memory
1. Press and hold the programming pushbutton.
2. Wait for the led to illuminate, then wait for it to turn off, followed by a flashing sequence.
3. Release the pushbutton precisely on the third flash to delete only the memorised
transmitters or on the fifth flash to clear all memory contents.
4. If the deletion procedure is successful, the led emits 5 flashes.
4
• Settings via radio are possible on all receivers located
within the operating radius of the transmitter, and there-
fore only the device required for the operation should
remain powered.
The user can check whether any transmitters are already memorised
on the TT2N control unit by simply checking the type of flash
sequence of the leds when the control unit is switched on.
Checking for memorised transmitters
2 long flashes (total 1.5s)
2 short flashes (total 0.4s)
No transmitter memorised
Transmitters memorised
Example
3s
Example
New 5s
Old X3
New
Example
4s
3s
Example
( )