CSI Controls CS1200 Guia Rápido página 2

STEP 2: Verifi cation
1. After the alarm is successfully connected to the wireless network, allow 2 minutes before
proceeding.
2. Using your internet connected device (i.e. Laptop, Desktop, etc.), open a new web browser
window or tab.
Note: you must be connected to the same router as your CS1200 WiFi Alarm.
3. Type the following into the address fi eld at the top of your web browser:
www.mywifi alarm.com or scan QR code.
4. Follow the registration link.
5. After reading and accepting the terms of the CS1200 WiFi Alarm, enter your alarm's
Unit ID# located on the back of the battery compartment cover. (DO NOT ENTER THE COLONS).
Click Confi gure.
NOTE: Before continuing, make sure device shows
a CONSTANT BLUE LIGHT
Please enter the Unit ID# on the label of your alarm system
This is found on the back of the Batery Compartment lid
This will be similar to
Configure
6. If the CS1200 WiFi Alarm has not been
verifi ed, you will be required to enter an email
address to receive a verifi cation link. Enter
your email address and press the REQUEST
VERIFICATION button.
Note: All future alarm notifi cations will be sent to
this verifi cation email address in addition
to the email addresses entered on the CS1200 WiFi
Alarm's setup page.
7. An email will be sent to the verifi cation email
address entered with a link to the Notifi cation Setup
page. Click this link to access the Notifi cation Setup
page. This email must be received and opened by
the same device used for the steps above.
8. If the CS1200 WiFi Alarm has already gone through the verifi cation process, the web
browser will immediately be redirected to the Notifi cation Setup page.
(not flashing light)
A1B5 C3D2 E7C2
WARNING!
USE ALKALINE BATTERY
ONLY, NON-ALKALINE
BATTERY MAY REDUCE
PRODUCT PERFORMANCE
UNIT ID#
A1B5:C3D2:E7C2
E2