CSI Controls CS1200 Guia Rápido página 3

STEP 3: Alarm Notification Setup
Notification Setup
At least one email address or one phone number must be provided to receive notification messages.
IP Address: 10.4.150.148
MAC Address: A1:B5:C3:D2:E7:C2
Battery Status: None (Hit F5 to refresh)
Network Name (SSID)
WPA2 Security Key
No Security
Device Name
Email Address 1
Email Address 2
Example: 123-456-7890
Text Message Phone Number 1
Example: 123-456-7890
Text Message Phone Number 2
Submit Submit
Note: A minimum of one email address or text message phone number must be entered to receive
alarm notifications.
2. Click Submit to save your notification data.
STEP 4: Setup Testing
1. Press and release the "TEST" button on the CS1200 WiFi Alarm. The alarm horn will sound and
the alarm light will activate while the "TEST" button is being held.
2. Verify that an alarm notification is received via email or text.
Note: It may take several minutes for the message to appear in your email inbox or message folder,
depending upon email server traffic or other circumstances. If you have not received a notification
within 5 minutes, verify the email address and/or cellular phone information is entered correctly and
that any email filters are set to allow messages from mywifialarm@mywifialarm.com.
While using a WiFi connection, a signal strength rating will also be sent with the alarm and power
restored notifications.
5.0 - 10.0 Great!
3.0 - 4.9 Good. No signal loss is expected.
2.0 - 2.9 Marginal. You may experience occasional signal loss.
0.0 - 1.9 Weak. Move alarm closer to wireless router.
1. On the CS1200 WiFi Alarm setup
page, fill in the appropriate data:
a. Device Name: Enter a unique
device name for each CS1200 WiFi
Alarm being installed.
EXAMPLE: "Cabin Sump Alarm"
Maximum 30 characters, including
spaces.
b. Email Addresses: Fill in the
email addresses which will
be receiving notifications
from the CS1200 WiFi Alarm.
c. Enter the phone number of
the device (or devices) that will
receive the text message.
E3