Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. C
(
ONTROLS
CONT
2.4
M
W
AIN
2.4.5 S
ETTING THE
The temperature unit displayed is factory set in Celcius (°C), but if desired, it
can be changed to Fahrenheit (°F).
Follow these steps:
NOTE: Prior to perform this
NOTE: To get back to °C for temperature display, repeat the complete procedure.
2.4.6 U
NIT
When it is time to perform maintenance on the unit, a wrench icon
appears on screen, no matter the mode the unit is in. Go to section 3.
Maintenance.
NOTE: This icon disappears when turning OFF the wall
'
)
D
C
U
ALL
ONTROL
SE
D
ISPLAYED
setting,
the
wall
control must be ON.
M
I
AINTENANCE
NDICATOR
control, but reappears when turning it back ON.
Once the maintenance has been done, reset the wall
control by pressing simultaneously on ECO and TURBO
keys. The wrench icon will disappear from screen.
(
'
)
CONT
D
T
U
EMPERATURE
NIT
Press and hold
on ECO key
during 4 seconds.
4 sec.
10
°F will flash on screen one
moment to show it is now
the current temperature unit,
then will stay on screen.
Publicidad
Tabla de contenido
Solución de problemas
