VOSS.farming easyCUT go Instrucciones De Uso página 29

Ocultar thumbs Ver también para easyCUT go:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 92
INSTRUCTION MANUAL VOSS.FARMING EASYCUT GO
Problem
Cause
Motor is very
Bearing seized
loud
1. Battery almost empty
2. Carbon brushes worn
Motor runs
very slowly
3. Rotor or stator
Problem
Cause
Upper blade
Defective reduction drive
does not move
Upper blade
1. Eccentric worn out
does not
move over the
2. Eccentric shaft
entire running
surface
1. Blade tension is too
Shaving head
gets very hot
2. Blades or head run dry
1. Eccentric defective
Blades do not
2. Primary reduction
cut
3. Shaving head worn out
1. Blade tension is too low
2. Blades have rust
3. Shearing blades are
Blades cut
badly
85340 | 02 | 2021 | V2
Motor
out
defective
Shaving head/blade
defective
high
gearing defective
blunt or not sharpened
properly
Solution
Contact the service department.
1. Change and charge the battery as
described in sections 7.4 and 9.1.
2. Contact the service department.
3. Contact the service department.
Solution
Contact the service department.
Contact the service department.
1. Adjust the tension of the blades with
the tensioning nut. If this solves the
problem and the device does not cut,
the blades must be sharpened.
2. Oil the blades/head.
Contact the service department.
1. Increase the tension of the clipper
blades with the tensioning nut.
2. Have the clipper blades resharpened
at a specialist shop. If there is too
much rust, replace the blades with
new ones.
3. Have the clipper blades resharpened
by a specialist.
DE
EN
EN
FR
IT
NL
SV
ES
PL
29

Publicidad

Tabla de contenido
loading

Productos relacionados para VOSS.farming easyCUT go

Este manual también es adecuado para:

8534085341

Tabla de contenido