Skil PWRCORE 20 CS4562B-00 Manual Del Propietário página 18

Filling Oil Tank with Bar and Chain Lubricant
To Attach/Detach Battery Pack
(Fig . 8)
WARNING
Therefore, remove the battery when
assembling parts, making adjustments,
cleaning, when the tool is not in use, or
when carrying it at your side. Removing the
battery pack will prevent accidental starting that
could cause serious personal injury.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool.
NOTICE: Make sure that the latch on the battery pack snaps into place and that the battery
pack is secured to the tool before beginning operation.
NOTICE: When placing the battery pack onto the tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
To detach the battery pack:
Depress the battery-release button, located on the front of the battery pack, to release the
battery pack. Pull the battery pack out and remove it from the tool.
To Fill the Oil Tank (Fig . 9)
WARNING
serious personal injury, always remove the
battery pack from the tool before filling the
tank with oil.
WARNING
oil or the chain saw. Oil may spill and cause a
fire.
NOTICE: The chain saw is not filled with oil at
the time of purchase. It is essential to fill the
tank with oil before use. Operating the chain
saw without chain oil or when the oil level is
below the minimum mark will result in damage
to the chain saw. Chain life and cutting capacity depend on optimum lubrication. The chain is
automatically lubricated with chain oil during operation.
1. Remove the battery pack from the chain saw.
2. Clean the oil tank cap and the area around it to ensure that no dirt falls into the oil tank.
3. Position the chain saw on its side on a firm, flat surface, so that the tank cap is facing
upwards. Rotate the oil tank cap counterclockwise to remove it (Fig. 9).
4. Carefully pour the bar and chain oil into the tank. Be careful not to let the oil spill from the
opening. Do not overfill and leave approximately 13/64'' (5mm) space between the oil level
and the inside edge of the tank to allow for expansion. Wipe off any excess oil.
5. Replace and fasten the cap.
18
Battery tools are always
in operating condition.
To prevent accidental
starting that could cause
Do not smoke or bring
any fire or flame near the
Fig. 8
Detach
Fig. 9
Oil Tank
Cap
Attach
Battery-Release
Button