Skil PWRCORE 20 CS4562B-00 Manual Del Propietário página 23

Notching undercut
Make the notch 1/3 the diameter of the tree,
perpendicular to the direction of fall, as
illustrated in Fig. 15. Make the lower horizontal
notching cut first. This will help to avoid
pinching of either the saw chain or the guide
bar when the second notch is being made.
Felling Back Cut
1. Make the felling back cut at least 2 inches (5
cm) higher than the horizontal notching cut
(Fig. 15). Keep the felling back cut parallel
to the horizontal notching cut.
Make the felling back cut so that enough
wood is left to act as a hinge. The hinge
wood keeps the tree from twisting and
falling in the wrong direction. Do not cut
through the hinge.
2. As the felling cut gets close to the hinge,
the tree should begin to fall. If there is any
chance that the tree may not fall in the
desired direction or it may rock back and
bind the saw chain, stop cutting before
the felling back cut is complete and use
wedges of wood, plastic or aluminum to
open the cut and drop the tree along the desired line of fall.
3. When the tree begins to fall, remove the chain saw from the cut, stop the motor, put the
chain saw down, then use the retreat path planned. Be alert for overhead limbs falling and
watch your footing.
Limbing
Limbing is removing branches from a fallen
tree. When limbing, leave larger limbs to
support the log off the ground.
Remove the small limbs in one cut as illustrated
in Fig. 16. Branches under tension should be
cut from the bottom up to avoid binding the
chain saw.
WARNING
the limbing operation. Be extremely
cautious and avoid contacting the log or
other limbs with the tip of the guide bar.
There is an extreme
danger of kickback during
Fig. 15
Notching Undercut
2 in.
(50.8 mm)
Direction of fall
Notch
Fig. 16
Tree Limbing
Limb Cut
Felling back
Cut
2 in.
(50.8 mm)
Hinge
23