Skil PWRCORE 20 CS4562B-00 Manual Del Propietário página 27

Assembling the New Bar and Chain
1. Remove the battery, allow the saw to cool and tighten the oil tank cap to prevent oil from
spilling.
2. Lay the new saw chain in a loop on a flat surface and straighten any kinks (Fig. 23).
3. Place the chain drive links into the guide bar groove. Position the chain so there is a loop at
the back of the guide bar (Fig. 24).
4. Hold the chain in position on the guide bar and place the loop around the sprocket of the
power head.
Fig. 23
NOTICE: Small directional arrows are engraved in the saw chain (Fig. 25a). Another directional
arrow is molded into the housing (Fig. 25a). When looping the saw chain onto the sprocket,
make sure that the direction of the arrows on the saw chain will correspond to the direction
of the arrow on the housing. If they face in opposite directions, turn over the saw chain and
guide bar assembly (Fig. 25b).
Fig. 25a
Sprocket Guide-bar Slot
5. Place the guide bar on the mounting surface by sliding the guide-bar slot over the alignment
flanges. Make sure that the guide bar is correctly positioned over the fastening bolt.
Cutter Direction
Alignment Flange
Fastening
Bolt
Fig. 24
Chain Drive
Links
Guide Bar
Groove
Fig. 25b
27