Checking For Leaks; Cleaning The Filter Screen - Glacier bay FP4A0052BNV Guía De Instalación Y Cuidado

Operation (continued)
2

Checking for leaks

Detach the pull-out spray (B) from the pull-out spray
hose (J). Hold the pull-out spray hose (J) firm to pre-
vent it from retracting into the faucet body (A).
Ensure the handle is in the off position. Turn the hot
and cold water supplies on and check all connections
for leaks. If leaks are discovered, check the connec-
tions to ensure they are tight and properly secured.
Lift the handle to allow the water to run for approxi-
mately one minute. This flushes away any debris that
could damage the internal parts.
Turn the water off and reattach the pull-out spray (B).

Cleaning The Filter Screen

CAUTION: Debris in the filter screen may result in
irregular or low water flow. Follow these steps to clean the
filter screen located in the pull-out spray (B).
1. Detach the pull-out spray (B) from the pull-out spray hose (J). Hold the pull-out spray hose (J) firm to prevent
it from retracting into the faucet body (A).
2. Flush the filter screen with water.
3. Reattach the pull-out spray (B) to the pull-out spray hose (J).
4. Turn water on to ensure water flow is no longer obstructed.
1
J
B
2 3
B
A
J
B
J
8
J
A
4
B
A