Checking For Leaks - Glacier bay FP4A4080SS Guía De Uso Y Cuidado

Installation (continued)
10
Connecting water supply lines
Connect the water supply lines (F) and tighten
the water supply nuts (1).
1
12

Checking for leaks

Remove the spray head (B) from the hose (K). Hold
the hose tightly to prevent it from retracting.
Turn on the water supply and check all of the
water connections for leaks.
If you discover any leaks, check the
connections to ensure they are installed properly.
Run the water for approximately 1 minute to
flush the lines.
Re-attach the spray head (B).
F
1
1
11
Attaching the weight
Locate the lowest point on the hose (L) and
attach the rubber weight (K) to the hose (L).
Use a Phillips screwdriver to secure.
B
8
L
K