Preliminary Test; How To Use The Sensilift Device - Sensica sensiLift ST100 Serie Manual Del Usuario

Preliminary Test

The preliminary test is intended
to determine your skins reaction
to the Sensilift treatment and
help you to find the best Sensilift
setting for each treatment area.
Do a preliminary test on each
area you intend to treat 48 hours
prior to the full first treatment.
1. Apply a thin, even layer of
"Base Gel", included in your
kit, on the area to be treated.
2. Select RF energy level 3 and
speed level 1.
3. Place the Sensilift device on
the desired treatment area
and start moving it in circular
motion in the treatment
area, for 3 minutes.
4.
The treatment will create a
warm sensation on your
skin. If you feel your skin is
heated too fast for you,
reduce the RF energy level.
The energy level should be
adjusted according to you
own comfort.
5. Select the speed level to 1
or 2 according to your own
comfort.
6.
Stop the test if you do not
feel comfortable or if you
see adverse e ects such as
severe redness or blistering.
7.
Wait 48 hours and examine
the tested area.
If the skin in the test area
seems normal (no adverse
e ects) you can proceed
with a full treatment in the
highest comfortable energy
level and speed level you
have tested.
Note: The RF energy level indicates
the rate at which the temperature
rises when in heating mode. A high
RF energy level will enable you
faster heating. You can achieve
maximum results with all RF energy
levels (for lower levels, it will just
take longer time to reach the
e ective temperature). Therefore,
select your optimal RF energy level
according to your level of comfort.
How to use Sensilift device
Note: Perform a preliminary test
before proceeding to a full
treatment for the first time. See
"preliminary test section" above.
See treatment areas, treatment
time and treatments schedule in
the "treatment protocol" section
below.
1. Apply a thin, even layer of
the "Base Gel" included in
your kit, on the area of your
skin intended for treatment.
Set the RF energy level and
2.
the speed to the level you
have selected in your
preliminary test treatment.
Press the RF energy level
selection button repeatedly
13