Danby DAC080B6IWDB-6 Manual Del Propietário página 16

INSTALLATION INSTRUCTIONS
Angled Support Arms
Move the angled support arms toward the exterior
wall until the feet touch the wall.
Place the level on the support bracket and adjust
the support arms so that it is tilted 1/4 bubble
downward toward the outside. The level bubble
should appear as shown.
Insert the main support pin through the holes in
the support bracket and angled support arms.
Ensure that the pins on both sides are in the same
numbered hole.
If further adjustment is needed, use alternate holes
where the main supports attach to the horizontal
bracket.
Check the level again and ensure the bracket feels
secure. After making any necessary adjustments,
insert the cotter pins into the main support pins.
If necessary, cover the holes in the front of the
bracket with the bracket sealing foam.
15