Remote Control Batteries; Remote Control Settings - Danby DAS120EAQHWDB Manual Del Propietário

OPERATING INSTRUCTIONS

REMOTE CONTROL BATTERIES

The remote control requires two AAA alkaline
batteries (included). Batteries should be replaced
when no sound is heard when using the remote
control or when the appliance does not respond to a
command issued by the remote control.
Battery replacement:
1. Slide the rear cover on the remote in the
direction of the arrow.
2. Insert two AAA batteries following the same
orientation depicted inside the battery chamber
(+/-).
3. Reinstall the rear cover.
4. If the remote control will not be used for
extended periods of time, the batteries should be
removed.
Notes:
• Protect the remote control from high
temperatures, and keep it away from radiation
exposure.
• Keep the control panel receiver out of direct
sunlight.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh,etc) batteries.
• The remote operates within a range of 8 meters
(26 ft.) from the receiver located inside the main
appliance. Any obstruction between the receiver
and remote may cause signal interference,
limiting the ability to program the main unit.

REMOTE CONTROL SETTINGS

On some models, when the batteries are replaced,
you need to set cooling only or heat pump control
type. As soon as you insert new batteries the sun
and snowfl ake symbol will fl ash on the display.
When the snowfl ake is displayed, push any button
to set the cooling only type remote control.
When the sun is displayed, push any buttons to set
the heat pump type remote control.
Note: If the remote is set to cooling only, the heat
function will not be available on units that include
a heat pump. If you need to reset the unit again,
remove and replace the batteries.
REMOTE CONTROL DIP SWITCH
On some models there is a dip switch inside the
battery compartment that can be used to manually
set cooling only or heat pump mode.
DIP switch position Function
°C
°F
Cool
Heat
17
Display will show °C
Display will show °F
Cooling only mode
Heat pump mode