TURNING OFF
Press the
button on the top side of your D CUBE and hold for 3
seconds to turn off.
AUX MODE
Connecting your D CUBE to your device using the 3.5mm AUX cable.
Startup:
1.
Connect your device using the provided 3.5mm stereo cable to
the AUX input of your D CUBE.
2. Start playback on your device.
The D CUBE power saving mode is disabled, when an AUX cable is
connected. When both AUX cable and Power In are connected your
D CUBE can be used stationary, e.g. as a PC speaker or TV soundbar.
STEREO LINK FUNCTION
Pairing two Dockin D Cube:
1.
Connect your Bluetooth playback device to one of the speakers
the usual way (see above)
2. Press the
-button twice on both speakers. This will enter ste-
reo link mode.
3. After a short time both units will be paired and a confirmation
sound can be heard. The left channel will have a higher pitched
sound playing after the initial confirmation for identification.
4. Start the music on the playback device. Both D CUBE speakers
will play back sound now.
6
The controls and volume changes are applied to both devices in Ste-
reo Link Mode.
The pairing information is stored. This will automatically reconnect
the speakers the next time they start up. The left / right assignment
is saved as well.
By pressing the Power button twice on one of the two D CUBE the
Stereo Link Function is disabled and playback is continued with only
one speaker.
CHARGING
Charge your D CUBE by using the provided power cable. The
charging input is located behind the cover on the side.
20%
50%
> 50%
During charging the LED is green. Once the device is completely
charged, the LED turns off.
Charging can be done with the supplied USB C charging adapter
and also with any USB C charger, the speed of the charging will de-
pend on the output specification. The supplied charger has an out-
put of 5V and 2A (Model HNBM050200UX)
POWER SAVING FUNCTION
If there hasn't been any signal transmission or charging via the USB
output for 15 minutes, your D CUBE turns off automatically. If the
AUX cable is connected the power saving function is disabled, which
allows stationary use.
7