Hart HLVC01 Manual Del Operador página 9

ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this leaf
vacuum. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the tool when assembling parts.
WARNING:
Rotating impeller blades can cause severe injury.
Always stop the motor, remove the battery, and ensure
impeller blades have stopped rotat i ng before removing
the inlet cover or installing/chang i ng tubes. Do not put
hands or any other object into the vacuum tubes while
they are installed on the unit. Failure to follow these
instructions can result in serious personal injury.
ASSEMBLING THE VACUUM TUBES
See Figures 2 - 3.
 Loosen the thumbscrew above the vacuum housing
outlet.
 Push the upper tube onto the vacuum housing outlet.
NOTE: The locking screw in the lower hole is pre-installed
and is spring-loaded. It will click into place when the upper
vacuum tube is fully inserted.
 Securely tighten the thumbscrew.
NOTE: The thumbscrew must be fully tightened or the
vacuum will not start. This prevents accidental starting
when the tube is not installed.
 Align the tabs on the lower tube with the slots in the upper
tube. Push the lower tube in until it clicks into place.
INSTALLING THE WHEEL ASSEMBLY
See Figure 4.
 Slide the wheel assembly onto the lower tube as shown,
with the wheels pointed toward the end of the tube.
 Press the tab on the wheel assembly and slide it up
or down to adjust its position according to operator
preference.
ATTACHING THE LEAF COLLECTION BAG
See Figure 5.
 Slide the bag opening over the curved lower opening in
the housing.
 Hook the bag onto the rear of the housing base.
 Pull the bag opening forward until it connects to the front
of the housing base and the tab clicks into place, securing
the bag to the housing.
 Slip the open-ended tab onto the hook on the upper tube
to fasten the bag to the tube.
7 – English