Troubleshooting Chart - Campbell Hausfeld TL050389 Manual De Instrucciones De Operación

Operating Instructions

Troubleshooting chart

SympTOm pOSSIbLe cAUSe(S)
Tool runs slowly or 1. Grit or gum in tool
will not operate
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
6. Regulator set too low
Moisture blowing 1. Water in tank
out of tool
2. Water in air lines/hoses
Chisel/Hammer is 1. Chisel/hammer piston and
jammed and will not
move back and forth
2. Chisel/hammer piston and
3. Piston is jammed in the barrel 3. Attempt to free jammed piston using a punch and hammer. It
Piston
Punch
* When reassembling the cylinder to the housing, use Loctite
www.chpower.com
barrel are dirty or rusty
barrel are rusted together
cOrrecTIve AcTIOn
1. Flush tool with Campbell Hausfeld air tool oil, gum solvent, or
an equal mixture of SAE 10 motor oil and kerosene. If Campbell
Hausfeld oil is not used, lubricate, tool after cleaning
2. Lubricate tool according to lubrication instructions in the Pre-
Operation section
3. Adjust the compressor regulator to tool maximum while the
tool is running free
4. Tighten and seal hose fittings if leaks are found
5. Be sure hose is properly sized. Long hoses or tools using large
volumes of air may require a hose with an I.D. of 1/2" or larger
depending on total hose length
6. Adjust regulator until tool reaches maximum speed
1. Drain tank (See air compressor manual). Oil tool and run until
no water is evident. Oil tool again and run 1-2 seconds
2a. Install a water separator/filter (PA2121). nOTe: Separators work
properly only when air stream is cool. Locate separator/filter as
far as possible from compressor
2b. Install an air dryer
2c. Anytime water enters tool, tool should be oiled immediately
1a. Heavily oil tool to free up piston
1b. Clean piston and barrel with air tool oil and remove any burrs
on piston or barrel surfaces*
1c. Replace worn piston and cylinder*
1d. Anytime water enters tool, tool should be oiled immediately
2. Remove piston and de-rust. Replace piston and cylinder if
needed *
may be necessary to disassemble barrel from housing. Clean
parts and reassemble *
on the cylinder threads.
®
4