5.
Operating instructions for seat heating units
Operation
The Single Element kit (On/Off control)
- The seat heating unit is switched on by moving the
switch upwards.
-
-
- 'ON'
Switch to the 'ON'. The LED will shine yellow. The
heat will be noticeable within 3 to 4 minutes. The hea-
ting must be switched off in order to avoid over-
heating, whenever the temperature is too high.
Troubleshooting
The heating does not function although it is switched on.
The LED is not luminated.
The LED is not luminated although the heating is
functioning and switched on.
The heating does not function although it is switched on.
The LED is on.
The distribution of heat in the seat or back is uneven.
The fuse burns out repeatedly.
FORM #15000024A, REV RTP, 12-04-06
© W.E.T. Special Products GmbH, Odelzhausen
The Seat Kit (High/Low/Off control)
- The seat heating element is switched on by moving
the switch upwards or downwards.
- 'High'
Switch on the 'High' setting. The LED will turn red.
The heat will be noticeable within 2 minutes. The
heating time can vary according to the type of seat
cover material and kind of clothing/coat that is being
worn. The heating must be switched to the 'Low'
setting in order to avoid overheating, when the
desired temperature has been reached.
- 'Low'
Switch on the 'Low' setting. The LED will turn green.
The heating time can vary according to the type of
cover and the kind of clothing that is being worn.
Check the fuse and change it if necessary. Consult a
specialized workshop if the fuse is in order.
The LED in the switch is defective.
The temperature of the seat cover could be too high due
to high interior temperature on the vehicle interior. The
thermostat in the seat heating unit is connected. Wait
until the seat cover's temperature has fallen and try
again.
Switch off the seat heating unit and consult a specialized
workshop.
Check the fuse rating. Consult a specialized workshop if
the fuse rating is correct.
16