Publicidad
Wall Mounting
Your Mybelle telephone may be mounted on any convenient upright surface. Simply fasten two screws 83mm
vertically apart and then locate the holes in the base of the phone onto them. The screws should be adjusted to
ensure that the phone is held firmly.
Important note Before fixing the screws to the wall, ensure that there are no pipes or electrical cables hidden in
the wall, behind the telephone position, which may be damaged by the screws. Wiring to electrical fittings will
usually be run vertically inside the wall. Therefore check that there are no electrical fittings either directly above
or below the location, before fixing screws into the wall.
Also make sure that the telephone line cord will reach the telephone wall socket from you chosen location.
Ringer Volume Switch
At the rear of the phone you will find a 3 position switch which can be used to adjust the ringer volume between
OFF, LOW or HIGH. Use the OFF position when you don't want to be disturbed.
= Low
= Off
Making an Outgoing Call
Pick up the handset and wait until you hear dial tone.
Dial the number you require on the keypad.
When the call is completed, replace the handset.
Last Number Redial
The Mybelle will store the last number dialled. This may be useful when calling a number that is busy or
unanswered. To redial the number -
Press and release the Hookswitch
Press the REDIAL button
Receive Volume Control
On the front edge of your telephone you will find a slider volume control. This control may be used to adjust the
volume of received speech. With the control set towards the right hand side of the phone, the received volume
will be at its maximum. With the control set to the left side, it will be at its minimum.
Memories
Numbers that are dialled on a regular basis may be stored in the memory and recalled by pressing either 1 or 2
buttons. Memories that are dialled by the press of a single button are called DIRECT and those that are dialled
by pressing 2 buttons are called IN-DIRECT. The Mybelle 630P has 2 DIRECT and 10 IN-DIRECT memories.
Important note During the storing of memories, a voice announcement similar to "Please replace the handset
and try again", may be received from your telephone exchange. This is normal and should be ignored. It will not
affect the corr
ect storing and subsequent operation of the memory.
Storing a number in DIRECT memory
Pick up the handset and press the STORE button.
Press the DIRECT memory button under which the number is to be stored (M1 or M2).
Enter the telephone number
Press the STORE button to complete the process.
Enter details of the number you have stored, on the index card provided under the handset.
= High
2
15
Publicidad
