Getting To Know Your Humidifier - Vicks EasyFill VUL570 Serie Manual De Uso Y Cuidado

Vicks EasyFill Cool Mist Humidifier (Model VUL570)
®
Components
1
1 Mist Outlet
2
2 Outlet Cover
3 Outlet Gasket
3
4 Tank Handle
5 Tank Opening
13
6 Tank Cover
7 Water Tank
8 Auto Shut-Off Float
9 Housing
10 Base
9
11 Power Knob
12 Scent Pad Door
10
13 Mist Chamber

Getting to Know Your Humidifier

How It Works
Water is released into the Reservoir when the Float Paddle engages the Plunger at the bottom of the Water
Tank. A Nebulizer vibrates at ultrasonic frequency, breaking the water into a fine mist. The mist is quietly
propelled by a fan up a vertical Mist Chamber to the Mist Outlet where the cool, visible mist enters the room.
This humidifier will shut off when the water level is low or when the tank is removed from the base.
Setting Up Your Humidifier
Unpack the Humidifier
Step 1
Step 2
Keep this instruction manual for reference.
1.
Remove packaging materials. Locate Float Paddle and set aside. This is required for operation.
2.
Locate the Demineralization Cartridge (included in some models) and set aside. This is
optional for operation.
3.
Remove twist tie and extend power cord. Place on a firm, level, water resistant surface
a minimum of 12 inches (30 cm) from walls.
4
6
5
4
14
7
14 Demineralization
Cartridge
8
17
(included in some models)
15 Plunger
19
16 Tank Gasket
18
17 Float Paddle
18 Air Outlet
19 Water Reservoir
11
20 Nebulizer
12
Step 3
Setting Up Your Humidifier
Float Paddle Installation – required for humidifier to operate
This humidifier uses a float system to regulate the water flow from the Tank to the Reservoir. The Float
Paddle must be properly installed for the unit to operate. If not properly installed, water may not flow into
the Reservoir or it may leak from the Base. The Float Paddle is designed to be easy to install and remove.
CAUTION: Improper placement of the Float Paddle could result in leaking or water
not feeding to the Reservoir.
16
Float
15
Rod
Float
Paddle
Step 3
"Click"
20
1.
Remove Water Tank.
2.
Line up Float Paddle with the float paddle shape on the bottom of the Reservoir.
3.
Place Float Rod over both Brackets and press firmly until you hear it click into both Brackets.
4.
Pull gently up on the Float Rod to be sure it doesn't pop out of the Brackets.
5.
Replace Tank in Base.
If using the optional demineralization cartridge, see next section Installing Demineralization Cartridge.
Hard Water and White Dust
High mineral content in your water, also known as hard water, may cause a white mineral residue to
accumulate on surfaces in the room near the humidifier. This mineral residue is commonly referred to
as white dust. The higher the mineral content (hardness) of your water, the greater the potential that an
ultrasonic humidifier may produce white dust.
White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals
suspended in the water you are using.
(Continued)
Step 2
Brackets Step 1
Step 5
Step 4
$
5