Safety Precautions; Technical Data; Charging Procedure - Carson Expert Indicaciones De Seguridad

This charger has been specially developed for 6-cell NiMH racing packs and 4-cell batteries ( for
example the Transmitter Reflex Wheel 3).

SAFETY PRECAUTIONS

Please note the following safety instructions. Failure to do so may
result in serious damage to the charger and batteries.
• Do not store the charger at temperatures below 5°C or over
50°C.
• Keep the charger away from dust, moisture, rain, heat, direct
sunlight and vibrations. Do not drop.
• Only use this charger on heat-resistant, non-flammable,
non-conductive surfaces. Never place it on carpets, car seats or
similar surfaces.
• Only charge power packs indicated in the instructions.
• Do not use a voltage or charge higher than that stipulated by
the manufacturer of the battery pack.
• Check carefully that the charger is set to the correct battery type
(e.g. LiPo, NiMh ) and the applicable technical specifications (e.g.
number of cells, voltage).

TECHNICAL DATA

500606071 2A+ charger:
Input voltage: 110-240V
Type of battery: NiMH
Number of cells: output 1: 6 cells ( 7.2 V) /
output 2: 4 cells (4.8 V)
Maximum charging current:
output 1: 2A / output 2: 0.5 A
Weight: 220g
Automatic switch-off: yes (both
outputs)

CHARGING PROCEDURE

1. Connect the charging unit to the mains cable supplied.
2. Connect this cable to a standard 100-240 V socket outlet.
3. Connect the battery/batteries to the respective output on the
charger.
4. Charging will now start.
5. The charger has automatic switch-off and a charging indicator
light for each output.
GB // 6
• A lithium polymer (LiPo) battery pack should be put in a LiPo
charging bag or on a fire-resistant surface during charging.
• If your battery shows evidence of any abnormalities during the
charging process (overheating, hissing, swelling), remove the
battery from the charger immediately and place it away from
people and flammable materials.
• Never take the charger apart nor make any modifications to it.
• Never attempt to use the charger to charge or discharge
non-rechargeable batteries or damaged battery packs.
• Keep the charger away from children.
• Never leave the charger unattended when connected to the
power supply.
Status LEDs:
Red LED: the battery is charging
Green LED: the battery is fully charged (the charger goes onto
trickle charge)
6. Remove the battery from the charger and leave to cool.
2
1