ASSEMBLY INSTRUCTIONS
1.
Remove the upper rubber grommet (1) from the
float assembly (B).
2.
Insert the top of the float assembly (B) into the switch
arm hole found on the sump pump A . Slide the
upper rubber grommet ( 1) removed in step 1 over
the end of the float assembly to secure the assembly
in place.
3.
Install the bracket (2) on the float assembly (B) to
the hole on the column of the sump pump (A),
ensuring that the pin
the hole on the column.
Adjust the position of the lower rubber grommet (3)
as necessary. The lower rubber grommet should be
between 5.5 in. and 9 in. from the top of the rod of
the float assembly.
Adjust the position of the upper rubber grommet (1)
as necessary. The upper rubber grommet should be
2 in. from the top of the rod of the float assembly.
( )
on the bracket is inserted into
1
1
B
2
3
5
1
B
1
3
2
B
Lowes.com
A
A