Taking A Reading; Changing Modes; Recalling Measurements In Memory; Replacing The Battery - MABIS Healthcare 18-607-000 Manual De Instrucciones

Taking a Reading

NOTE: Many pediatricians recommend the use of ear thermometers for
children older than 6 months.
1. Press and hold the SCAN button for one second,
then release. The system will perform a self-test,
Fig.1.
2. After performing the self-test, the display will show
the last temperature taken, Fig. 2. The thermometer
will beep indicating that the unit is ready for
measurement.
3. Gently insert the probe snugly into the ear canal
until a slight resistance is felt. Press the SCAN
button, Fig. 3, and promptly release the button.
4. FeverVue TM Technology will change the display to the
appropriate color for the temperature measurement.
If Green there is no fever, Orange means a slight
fever and Red indicates a high fever, Fig.4.
5. If the measurement is below 100.4°F (38°C),
the thermometer will beep once and the
measurement will be shown on the display
with a happy face symbol, Fig. 5.
6. If the temperature is 100.4°F (38°C) or above, the
thermometer will sound one long beep followed by
two short beeps. The measurement will be shown on
the display with a sad face symbol to indicate fever,
Fig.6.
7. Thermometer will automatically beep and shut off
after approximately 1 minute of non-use.
NOTE: To ensure accuracy,
1. Please wait at least 5 seconds between successive readings.
2. Clean the probe lens before and after each use.
Fig. 1
Fig. 2
Fig. 3
Green
97°F-98.9°F
(36.1°C-37.1°C)
(no fever)
99°F-100.9°F Orange
≥101°F
(37.2°C-38.2°C)
(slight fever)
(high fever)
(≥38.3°C)
Fig. 4
Fig. 5
Fig. 6
8
Temperature readings can be displayed in either
Fahrenheit or Celsius. To switch between °F or °C,
press and hold the SCAN button. Without releasing,
also press the 'M' button and toggle between the
modes, Fig. 1 and 2.

Recalling Measurements in Memory

The last 10 measurements taken are automatically
stored into memory. To recall measurements, press
the SCAN button to turn the unit on. After the unit
beeps, press the 'M' button to view measurements
in memory. Continue to press the 'M' button to view
the next previously stored measurement, Fig. 1.
The unit will beep each time a recorded
measurement is viewed.
Red
Your Deluxe Instant Ear Thermometer requires one lithium battery, type
CR2032. The battery needs to be replaced when
the low battery symbol appears on the display.
To replace the battery:
1) Unscrew and slide off the battery cover.
2) Using a non-metal pointed tool, carefully
remove the battery and insert the new
battery with the positive (+) side facing up.
3) Replace the battery cover.
NOTE: Please properly dispose the battery
away from small children and heat.

Changing Modes

Replacing the Battery

9
Fig. 1
Fig. 2
Fig. 1
Memory Index
Symbol