Dirt Container & Filter: Removal & Replacement; Belt Or Brushroll: Removal & Replacement - Dirt Devil m088160 Manual Del Propietário

DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
NOTE: Unplug cleaner before changing filter.
NOTE: For best performance, replace pleated filter yearly.
FILTER TYPE
For F1 filter replacement, please visit our website at www.dirtdevil.com to buy
F1
online or call customer service at 1-800-321-1134.
EMPTY AND CLEAN DIRT CONTAINER
2.
1.
Depress latch to remove dirt Remove lid by grasping both
container from cleaner. handles and turning lid
counterclockwise.
5.
4.
Twist and pull the filter up and Clean filter and empty dirt
out. container completely. See
"Regular Maintenance" note
below for instructions on
cleaning the filter.
*Regular Maintenance: Each time the dirt container is emptied, the pleated filter should be cleaned. Tap the filter
firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use,
this will not affect the filter's performance.) Do not brush the filter. The cleaning instructions may vary depending
on the dirt conditions. In some cases, more or less cleaning of the filter may be required. It is recommended that
the filter be replaced once per year.
3.
Hold the dirt container and
grasp the top of filter.
6.
Return filter to dirt container.
Push filter into place to prevent
dirt leakage. Return dirt
container to cleaner.
9
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
BELT STYLE
For Belt Style 5 replacements, please visit our website at www.dirtdevil.com to buy
5
online or call customer service at 1-800-321-1134.
TO REMOVE BELT
2.
1.
Lay cleaner flat and flip cleaner Lift nozzle guard off.
to expose nozzle base. Base
should lay flat and face up. To
remove nozzle guard, use
Phillips screwdriver to remove
the four (4) screws. Arrows
show location of screws.
TO REPLACE BELT OR BRUSHROLL
4. 5.
END CAP
Lift and remove brushroll. Place new belt in area of
Dispose of old belt. brushroll without bristles.
7. 8.
7a.
With new belt in place, pull and Reattach nozzle guard.
slide brushroll into nozzle making
sure that the brushroll end caps
are in the correct orientation (7a
inset). Rotate brushroll manually to
make sure belt is properly aligned.
3.
Slide belt off motor shaft.
6.
Slide belt onto motorshaft.
9.
TAB TAB
Secure by aligning the three
(3) tabs in the base slots. Be
sure to replace all four (4)
screws.
10
TAB