Lightbulb: Removal & Replacement; General Maintenance; Troubleshooting Guide - Dirt Devil m088160 Manual Del Propietário

LIGHTBULB: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement, please visit our
website at www.dirtdevil.com to buy online or locate a dealer nearest you.
1. 1a.
Depress latch to remove dirt container
from cleaner. Remove the two (2) screws
located on the inside of the (Diagram 1).
Remove lens (Diagram 1a).

GENERAL MAINTENANCE

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
IF OBSTRUCTION DEVELOPS DURING FLOOR CLEANING:
1. If obstruction develops while cleaning carpets, turn cleaner OFF and unplug. Check to see if dirt container is full
(Diagram 1); empty if needed (Page 9).
2. Check dirt path window and lower hose (Diagram 2). Remove any obstruction.
3. Turn cleaner over and remove nozzle guard (Diagram 3). Clear any obstruction that occurs in or around the
brushroll area.
IF OBSTRUCTION DEVELOPS DURING ABOVE FLOOR CLEANING:
1. If obstruction develops while above floor cleaning, turn cleaner OFF and unplug. Check to see if dirt container is
full; empty if needed (Page 9).
2. Check airflow areas of hose (Diagram 4). If there is no suction, disconnect hose, drop quarter through end. If
quarter comes out, there is NO blockage.
1. 2.
2. 3.
Pull bulb out of socket to Replace lens. Secure the
remove. Do NOT twist. Gently headlight lens by replacing
push new bulb into socket to the two (2) screws.
replace.
3. 4.
11

TROUBLESHOOTING GUIDE

WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM POSSIBLE REASON
Cleaner won't run 1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
Cleaner won't
1. Dirt container not installed correctly.
pick-up or low
suction
2. Dirt container full.
3. Brushroll worn.
4. Broken or worn belt.
5. Clogged filter.
6. Nozzle/dirt passage hose clogged.
Dust escaping
1. Dirt container full.
from
2. Dirt container not installed correctly.
cleaner
3. Hose not connected correctly.
4. Filter not installed completely.
Cleaner tools won't
1. Hose clogged.
pick-up
2. Dirt container full.
3. Filter clogged.
Headlight not
1. Bulb burnt out.
working
2. Loose electrical wires.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center. To find nearest location,
visit our website at www.dirtdevil.com or call
1-800-321-1134.
4. Allow cleaner to cool - Pg. 3.
1. Review dirt container removal & replacement -
Pg. 9.
2. Empty dirt container - Pg. 9.
3. Replace brushroll - Pg. 10.
4. Replace belt - Pg. 10.
5. Remove filter and clean - Pg. 9.
6. Remove lower hose; remove obstruction - Pg. 8.
1. Empty dirt container - Pg. 9.
2. Review dirt container removal & replacement -
Pg. 9.
3. Review hose installation - Pg. 7.
4. Review filter removal & replacement - Pg. 9.
1. Remove hose and tools; remove obstruction -
Pg. 8.
2. Empty dirt container - Pg. 9.
3. Clean filter - Pg. 9.
1. Replace bulb - Pg. 11.
2. Take to service center. To find nearest location,
visit our website at www.dirtdevil.com or call
1-800-321-1134.
® Dealer or visit
®
12
Dealer or