Fox F20-140A Manual De Instrucciones página 23

18. Block the piece. If possible, use C-clamps or a holder to fix the piece. It is safer than using
only your hands.
19. Keep the tools in perfect conditions. Keep the tools sharp and clean to obtain better and
safer results. Follow the instructions to grease and change the accessories. Check
regularly the electric cable and change it if it is damaged. Keep the handles and the
handgrips dry, clean, unoiled and ungreased.
20. Disconnect the tool from electricity if you do not use it, before maintenance and change of
the accessories or tools such as blades, drills, mills, etc.
21. Remove locking and adjustment wrenches from the workbench. Get used to check if the
locking and adjustment wrenches have been removed before starting it.
22. Check the parts of the tool to verify that there are not any damages. Before using the
machine, check if the safety devices or any other parts are damaged in order to be sure
that it works properly and that it can accomplish the tasks for which it has been designed.
Check that the moving parts are aligned, do not stop and are not broken. Check the
assembly and any other condition that can influence the functioning of the machine. Any
part or protection damaged must be repaired or changed from an authorised after sales
centre. Do not use the machine if the switch does not work properly.
23. Use the machine, the tools and accessories in the way and for the purposes mentioned i
this manual. Different uses and parts can cause possible risks for the operator.
24. Get the machine repaired by a qualified person. This electric tool is in compliance with
local safety regulations. The machine must be repaired only by qualified people who use
original spareparts, otherwise risks may arise for the operator.
23