Mopar 82212517 Manual Del Usuario página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Steering wheel removed for clarity.
53. Push the tilt lever (5) downward.
54. Install the lower shroud (2) over the tilt lever and onto
the column.
55. Position the column tilt (5) at the full­upward position.
56. Push the tilt lever (5) upward, locking it in place.
57. Install the screw (3) attaching the lower shroud (2) to
the steering column (6).
58. Position the column tilt at the full­downward position
and lock it in place.
59. Attach the PIA edge biter clip (1) to the lower shroud
(2).
60. Install the upper shroud over the lower shroud, clip­
ping the shrouds to one another.
61. Install the two screws attaching the upper shroud to
the lower shroud.
62. Position the instrument cluster (1) close enough to
the instrument panel to reconnect the instrument
panel wire harness connectors to the connector
receptacles on the back of the cluster housing.
63. Position the instrument cluster mounting tabs to the
mounting holes in the instrument panel armature (2).
64. Install and tighten the four screws (3) that secure the
mounting tabs of the instrument cluster. Tighten the
screws to 2 N∙m (17 in. lbs.).
19

Publicidad

Tabla de contenido
loading

Tabla de contenido