Mopar 82212517 Manual Del Usuario página 20

20
65. Reconnect the two connector insulators of the
instrument panel wire harness take outs to the
airbag inflator connector receptacles on each side
of the airbag housing by pressing straight in on the
connectors, then pushing the locks straight into the
connectors. Be certain to engage each keyed and
color­coded connector to the matching connector
receptacle.
66. Position the passenger side I/P cover (1) to the I/P.
Make certain that the upper passenger airbag bracket
is engaged with the stud and under the nut on the
windshield fence line and that the two lower studs of
the airbag are engaged in the holes of the instrument
panel armature.
67. Push the edges of passenger side I/P cover (1) to the
I/P to engage the snap retainers.
68. Install the two grab handle to I/P bolts. Tighten the
bolts securely.
69. Install the grab handle applique by pushing the edges of the grab handle applique (1) into the grab handle to engage
the retainers.
70. Install the two bolts to the grab handle applique (1).
71. Install and tighten the two nuts (3) that secure the pas­
senger airbag lower studs to the instrument panel ar­
mature. Tighten the nuts to 6 N∙m (55 in. lbs.).