Tools Required; Drain Pump Installation; Converting A Gravity Drain Model - Marvel AGA 115VAC Instrucciones De Instalación, Operación Y Mantenimiento

Tools required

Pliers
Phillips screwdriver
Flat bladed screwdriver
⁄ " Hex head nut driver
5
16
A cordless drill driver with the above bits is recommended if
available.
NOTE
If your ice maker has been making ice, you need to re-
move all ice and drain the reservoir in the ice maker before
installing the drain pump. Refer to the ice maker owners
manual for information on how to do this.

Converting a gravity drain model:

1) Remove the ice machine from the installation
and unplug the power cord from the electrical
outlet.
2) Remove the front panel and the toe grille from
the ice machine by removing the 4 phillips head
screws. (See Figure 2 and 2a).
3) Remove the support bar by removing the 2
phillips head screws as shown in Figure 3.

DRAIN PUMP INSTALLATION

Front
panel
Figure 2
Toe grille
Figure 2a
Figure 3
Support bar
3
Front
panel
Toe grille
Phillips head
screw
Support bar