Unit Start Up - Black and Decker Price Pfister Portland 34 Serie Manual Del Usuario

14
14F
14B
14C
14A
14G
14A
14 FAUCET PREPARATION
From underneath faucet, remove Nut (14A) from Mounting Post (14B). Remove Putty
Plate (14C) and Deck Plate (14D) from Faucet Body (14F). Assemble Mounting Ring
(14E) and Putty Ring (14G) to Faucet Body (14F). Secure by placing and threading Nut
(14A) onto Mounting Post (14B).
15
15B
15 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Putty Ring (15A). Insert the faucet Supply Tubes (15B) through the center
hole of the sink.
14D
14F
14B 14E
15A
ENGLISH
16
16 SECURING FAUCET TO DECK
Remove any excess putty from around the outside edge of Mounting Ring (16A). From
underneath sink, secure the faucet by placing the Metal Washer (16B) and the Long
7
Nut ( / Hex.) (16C) onto the Mounting Post (16D). Make sure that the bumps on the
16
Metal Washer (16B) are facing up. Tighten until the faucet is firmly connected to the
sink. Do not over tighten!
17
17D
17B
17C
HOT
17 WATER SUPPLY LINES
Gently separate hot and cold Supply Tubes (17A), approximately three inches apart.
Connect water Supply Lines (17C) to Faucet Inlets (17B). Hot water supply line goes to hot
inlet fitting indicated by red tag (17D). (Supply lines not included). Follow manufacturer's
instructions when installing supply lines. Do not twist Supply Tubes (17A)!
18

18 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.
Note: After installation is complete, flush faucet (see step 22).
5
16A
16D
16B
16C
17A
17A
17B
17C
COLD