To Do Before You Operate The Product; Vibration Frequency And Operation Speed; Operation; To Connect The Battery To The Product - Husqvarna BV 30i Manual De Usuario

b) Loosen the lock bolt (J).
K
c) Turn the eccentric element (K) to adjust the
weight. The table below shows how much the
eccentric element must be turned with different
beams and different slump concrete. There are 4
marks on the eccentric element, 62%, 75%, 87%
and 100%.
Introduction
WARNING:
safety chapter before you use the product.

To do before you operate the product

• Read the operator's manual carefully and make sure
that you understand the instructions.
• Make sure that the battery is charged.
• Connect the battery to the product.
• Do the daily maintenance. Refer to
schedule on page 13 .
Vibration frequency and operation
speed
It is necessary to adjust the vibration frequency to the
condition of the concrete. For concrete that contains a
low quantity of water, a higher vibration frequency is
necessary. For concrete that contains a high quantity of
water, a lower vibration frequency is necessary.
Differences in the speed of the movement and the
vibration frequency gives different results.
Decrease the speed if the beam shakes too much or
makes too much slurry on the surface. Increase the
speed if the beam does not make sufficient slurry on
surface.
1
Lowest water contents in the slump concrete.
2
Highest water contents in the slump concrete.
10
J

Operation

Read and understand the
Maintenance
Beam
length,
m/ft
1
S1
1.82/6.0 N/A
2.44/8.0 N/A
3.05/10.0 N/A
3.66/12.0 N/A
4.26/14.0 N/A
d) Tighten the lock bolt.
e) Install the cover for the eccentric element and the
4 screws.

To connect the battery to the product

WARNING:
original batteries in the product.
1. Make sure that the battery is fully charged.
2. Put the battery into the battery holder of the product.
The battery must move into the holder easily. If not,
it is not installed correctly.
3. Push the battery in fully into the battery holder. The
battery locks into position when you hear a click.
4. Make sure that the latches lock in position correctly.
Slump concrete
S2 S3 S4 S5
100% 75% 62% 62%
100% 87% 75% 62%
100% 87% 75% 62%
100% 100% 87% 75%
100% 100% 87% 75%
Only use Husqvarna
1493 - 001 - 27.05.2021
2