To Start The Product; To Operate The Product - Husqvarna BV 30i Manual De Usuario

To start the product

1. Connect the battery to the product.
2. Push and hold the ON/OFF button (A) until the
battery indicator (B) comes on.
A
3. Use the power trigger to control the speed.

To operate the product

1. Spray the beam with concrete form oil or concrete
release agent. This makes it easier to clean the
product after operation because the concrete does
not attach to the beam.
2. Put the beam at the start of the first section of the
concrete surface.
3. Start the product. Refer to
page 11 .
4. Hold the handles tightly.
5. Push the power trigger to start the operation. Use
the power trigger to adjust the vibration force.
1493 - 001 - 27.05.2021
B
To start the product on
CAUTION:
vibration force, slurry can collect on the
surface. If you use too low vibration
force, it is possible that all air bubbles
are not removed from the concrete.
Note:
The product stops automatically if you do
not operate it for 5 minutes.
6. Push the cruise control button to set the selected
vibration frequency. Refer to
control function on page 12 .
7. Walk slowly rearward and at the same time lift the
product until the rear edge of the beam is slightly
lifted. The vibrations remove your shoe prints from
the concrete surface.
8. Put 30-35 cm/11.8-13.8 in. of the beam on the
smooth concrete surface to make an overlap on the
next section of the concrete surface.
9. To make areas of concrete level, do the procedure
that follows.
a) In the 4 corners, make 30-45 cm/11.8-17.7 in.
diameter of wet concrete areas (A) with a hand
float. Use a laser to make sure that the wet
concrete areas have the correct level. The
distance between the outer edges of the wet
concrete areas must not be more than the length
of the beam.
A
b) Operate the product between the wet concrete
areas to make 2 parallel strips (B). The strips
must be 30-45 cm/11.8-17.7 in. wide.
B
If you use too much
To operate the cruise
11