Putting The Machine Into Service; Before Starting The Engine; Starting Work - Grillo PRINCESS 9 Manuel De Uso Y Mantenimiento

INSTRUCTIONS FOR USE

PUTTING THE MACHINE INTO SERVICE:

1) make sure the machine is complete and that has not been damaged in transit.
6) Fill engine oil to level (refer to relevant engine handbook).

BEFORE STARTING THE ENGINE

– Fill the tank with fuel.
STARTING THE ENGINE
– Open the fuel tap.
– Bring the throttle lever half way of its journey. If the engine is cold, turn the starter lever to CHOKE.
– Start the engine by pulling the pull-start handle hard.
– Once the engine is running, return the starter lever to RUN and the throttle lever almost to the mini-
mum setting.
CAUTION:
BEFORE ANY OPERATIONS ON THE ENGINE, REFER TO THE SPECIFIC HANDBOOK.

STARTING WORK

– Adjust the height position of the handlebar to obtain the optimum working position, using the relative
–
In the MR, 2 MR, PRO 2 MR models pull the RM lever to engage reverse gear. (Safety device: if it is
released even accidentally, the machine stops).
END OF WORK
engine manual.
SERVICING
The cultivator is constructed to require very little servicing, but the following instructions should be fol-
lowed to keep it in perfect working order:
– Follow all the instructions in the engine handbook. It is essential to check the oil level every 4
working hours and change it about every 50 hours. Refer to the enclosed engine handbook for the
oil type.
screws.
– Oil the throttle and clutch cables.
9