Hayward AquaVac 6 Serie Manual De Usuario página 18

INSTALL
The AquaVac 6 Series Control Unit can be installed and
used in different locations:
1. Sitting on its kickstand, on a table or on the pool deck
2. Using the wall mount attachment fixture located on the back
of the control unit (Mounting screw template supplied on the
reference guide)
3. Positioned on the caddy cart control unit cradle
To find the best location for your control unit, please
consider the following:
• The control unit should preferably be kept in a shady area
and the cooling fan kept unobstructed.
GFCI
110/220 V
50Hz/60Hz
Connect the cleaner cable to the control unit and plug the
control unit cord into a protected outlet.
Control Unit Set-Up
2.25"/57.15mm
Cleaner Set-Up
220/230 V
240 V
50 Hz 50 Hz
RCD
• Leaving the control unit on the pool deck is acceptable but
precautions should be taken so it does not get damaged by
regular traffic around the pool or by playing children or pets.
• The cleaner control unit should be located at least
3.5 m (11.5 ft.) from the closest edge to the pool.
• To reduce the risk of electric shock, DO NOT USE AN
EXTENSION CORD to connect unit to electric supply.
• Based on your region of the world, the cleaner control unit
must be connected only to a supply circuit protected by a
ground-fault circuit-interrupter (GFCI) or a residual
current device (RCD).