1-04-2006
11:36
Pagina 41
NING AND MAINTENANCE
ING THE
Cleaning the work area: remove the worktop,
NE
lifting it up from the front and sliding it out.
press the main switch and
Remove the water collection dish underneath
and clean everything with hot water and clean-
sers.
Cleaning the bottom: To clean all the chro-
mium-plated areas, use a soft, damp cloth.
8.3
The stainless coffee-holders are situated under
Fig. 28
the delivery units, as shown in figure.
NG THE OUTSIDE
MACHINE
y cleaning operation, the
off from the power supply
and unplugged).
NOTE: To clean proceed as follows:
Fig. 29
ARNING
s, chlorine-based pro-
All manuals and user guides at all-guides.com
CLEANING THE STAIN-
LESS COFFEE-HOLDERS
• Turn the screw placed in the centre of
the coffee-holder.
• Slide the coffee-holder out and check
that its holes are not obstructed but
clean.
• If obstructed, clean as described
(Paragraph "CLEANING FILTERS
AND FILTER-HOLDERS")
We recommend cleaning the coffee-
holder once a week.
8.4
CLEANING THE UNIT
WITH THE AID OF THE
BLIND FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
RISK OF INTOXICATION
Once the filter-holder has been removed,
repeat delivery operations a few times to eli-
minate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
1) Substitute the filter with the delivery unit
blind filter.
2) Fill it with two spoonfuls of special cleanser
powder and insert it into the unit filter-holder.
3) Press one of the coffee keys and halt it after
10 seconds.
Fig. 30
4) Repeat the procedure several times.
5) Remove the filter-holder and carry our a few
deliveries.
8.5
CLEANING FILTERS
AND FILTER-HOLDERS
Place two spoonfuls of special cleanser in half
a litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.
CAUTION
41