Metra Lariat Instrucciones De Instalación página 5

1. Cut and remove the top (2) mounting
holes off of the radio housing.
Note: The notch in the housing
should be on top. (Figure A)
2. Slide the included brackets onto
the sides of the radio housings
pocket from the back of the
housing forward. (Figure B)
3. Mount the ISO Brackets to the
head unit with the screws supplied
with the unit. (Figure C)
4. Slide the head unit into the radio
opening until the side clips engage.
(Figure D)
5. Snap the trim plate into the Radio
Housing. (Figure D)
6. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
7. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-5822
ISO radio provision with pocket
CUT HERE -TOP LEG ONLY
CUT
(Figure A)
(Figure C)
CUT HERE -TOP LEG ONLY
CUT
(Figure B)
(Figure D)
5