Black+Decker LI2000 Manual De Instrucciones página 22

22 • ENGLISH
f Do not use screwdriver as a pry bar in any position.
f To avoid screwdriver being turned on accidentally,
do not carry in your pocket.
OPERATING
Operating in power mode
Forward
f Rotate the collar (4) to the position marked as shown
in (Fig. F)
f Slide the Forward/Reverse switch (1) to the right,
exposing the arrow pointing forward as shown in
(Fig. F)
f Press the button on the switch and the tool will run;
release the button and the tool will stop.
Reverse
f Rotate the collar (4) to the position marked as shown
in (Fig. F1)
f Slide the Forward/Reverse switch (1) to the left,
exposing the arrow pointing backward.
f Press the button on the switch and the tool will run;
release the button and the tool will stop..
Forward/Reverse/Lock-Off slider
When the Forward/Reverse slider (1) is in the central
position the tool is locked off to prevent accidental
actuation or battery discharge.
OPERATING IN MANUAL MODE
f Rotate the collar to the position marked as shown in
(Fig. G)
f Use the tool as any conventional non-powered
screwdriver. When the Forward/Reverse slider (1)
is in the central position the tool is locked off
to prevent accidental actuation or battery discharge
Screw driving
f Before installing bits, move the Forward/Reverse
slider (1) to the center "lock-off" position.
f Insert the appropriate hex shank screwdriver bit into
the spindle.
f Select forward or reverse rotation.
Drilling
1.
f Before installing bits, move the Forward/Reverse
slider (1) to the center "lock-off" position.
f Insert the appropriate hex shank drill bit. f Select
forward rotation.
Nota: Al perforar, es posible que la broca se
desconecte del eje al momento de retirarla del
material. Si esto ocurre, para retirar la broca se debe
insertar nuevamente el vástago hexagonal dentro del
eje y operar la herramienta en la dirección opuesta.
GENERAL DRILLING TIPS
f This tool is not recommended for drilling in masonry.
f Use sharp drill bits only.
f Drill bits for metal can be used for drilling holes in
wood. These bits must be sharp and should be pulled
out frequently when drilling to clear chips from the
flutes.
f Support and secure work properly, as instructed in
the safety Instructions.
f Use appropriate and required safety equipment,
as instructed in the safety instructions.
f Secure and maintain work area, as instructed in
the safety instructions.
f Apply pressure in a straight line with the bit. Use
enough pressure to keep the bit biting but not so
much as to stall the motor or deflect the bit.
f Hold the tool firmly to control its twisting action.
f Do not click the trigger of a stalled tool off and
on in an attempt to start it. Damage to the tool
can result.
f Minimize stalling on breakthrough by reducing
pressure and slowly drilling through last part of hole. f
Keep themotor running while pulling the bit out of
a drilled hole. This will help reduce jamming. f Make
sure switch turns tool on and off.
Warning! It is important to support work properly and to
hold the tool firmly to prevent loss of control which could
cause personal injury.
MAINTENANCE
Keep guards, air vents and the motor housing as clear as
possible of dust and dirt. Wipe with a clean cloth and blow
through with a low-pressure air supply. Excessive build-up
of metal dust can cause tracking of electrical current from
the internal parts to exposed metal parts.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Warning! The use of any accessory not recommended
for use with this tool could be hazardous.