Electrical Safety; Safety Guidelines - Definitions - Black+Decker BC12 Manual De Instrucciones

26 • ENGLISH

3. Electrical safety

Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
BLACK+DECKER Service Center or an equally
qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally
qualified person, but not authorized by
BLACK+DECKER, the warranty will not be valid.
4. Labels on tool
The label on your tool may include the following
symbols:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
Use Ear
Protection
V ........ Volts
n .......
0
A ........ Amperes
FEATURES (Fig. A and B)
1. Display Panel: It can indicate present voltage,
present current, present battery capacity or wrong
condition code. With AC power input, when not
connected to the battery, the charger shows that
there is no power output with the display panel present
moving "8". After connected to the battery, the panel
will display the battery information according to
what you choose. If the battery voltage is higher than
13.6±0.2V, the panel will displays "FUL".
When error occurs, the panel displays error code.
The meanings of the codes and the solutions are
enumerated in the troubleshooting table.
2. Current Indicator: It is a green LED indicator. When
the display panel indicates the present current, this
LED indicator illuminates.
3. Voltage Indicator: It is a green LED indicator. When
the display panel indicates the present voltage, the
voltage LED indicator illuminates.
4. Battery Capacity (%): When the display panel
indicates the battery level, this LED indicator will
illuminate.
Code
LO
60~90
FUL
5. Automatic Charging Indicator: it indicates the
charging rate you choose is automatic.
6. 2A Current Indicator: It indicates the charging rate
you choose is 2A.
Hertz
...... Class II
Watts
....
minutes
..... Alternating
....
Current
..... Direct
.../min..
Current
No-Load
Speed
Condition
low Battery
Current battery level
Full Battery
7. 8A Current Indicator: It indicates the charging rate
you choose is 8A.
8. 12A Current Indicator: It indicates the charging rate
you choose is 12A.
9. Charging State Selecting Switch: You can choose
the charge rates 2A, 8A or 12A, by pressing this
switch.
10. Display Button Switch: You can choose what to
display on the panel by pressing the button. The
default display is the current charging rate.
11. Reverse Polarity LED Indicator: The LED light will
be red when clips connected the battery in the wrong
way.
12. Battery Recondition Indicator: It is a yellow LED,
Construction
when the battery is reconditioned, this LED flash.
Earthing
Terminal The charger will estimate automatically whether the
battery recondition is needed. It will recondition the
Safety Alert
Symbol
battery only when the battery has gone into float
Revolutions
charge and the voltage is lower than 13V. The process
or Recipro-
cation per
cycles every 4±0.5h until the voltage is higher than
minute
13V. If it cycles 5 times and the voltage is still lower
than 13V, there will be a code "F01" present on the
display panel, indicating error. Please replace the
battery.
13. Charging State LED Indicator: It is a green LED,
when battery is charged at a constant current or a
constant voltage, the green LED flash. When the
battery goes into float charge, the charger will cut
receiving power to battery for1 minute to check the
charging state. At this time, the green LED illuminates.
If it checks the battery is full charged or goes into float
charge, this green LED will illuminate steadily.
14. Cooling Fan: Built-in high-speed cooling fan.
When you charge battery in the constant current or
constant voltage condition, and the current is higher
than 3.5A,or temperature is more than 122ºF (50ºC)
fan will run automatically.
SAFETY GUIDELINES: DEFINITIONS
Danger! Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Warning! Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
Caution! Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
Caution! Used without the safety alert symbol indicates
potentially hazardous situation which, if not avoided, may
result in property damage.