Maintenance And Care; Protecting The Environment - Black+Decker BC12 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery reconditioning mode
If a battery is left discharged for an extended period
of time, it could become sulphated, unable to accept
a charge. Reconditioning Mode may help reverse
the effects of sulphation and restore a batteries
ability to accept a charge. If the charger detects a
sulphated battery, it will automatically activate Battery
Reconditioning mode, indicated by a blinking yellow
LED. And the digital display will show you "-" in
turns. If successful, normal recharging will resume
after the battery is desulphated. If the first attempt at
desulphation is unsuccessful, the battery charger will
make up to four more attempts. If still unsuccessful
at desulphating the battery, fault code "F01" will be
displayed indicating the battery will not accept a charge
and should be replaced.
Aborted charges
If charging can't be completed normally, charging will be
aborted. The digital display may show a fault code. To
reset the charger after an aborted charge, disconnect the
battery or unplug the charger.
Battery diagnotics
The charger continuously monitors battery condition and
may report certain charging failures as fault codes. Refer
to the section called "Fault codes" for a complete list.
Cooling fan operation
The charger is designed to control its high speed cooling
fan for efficient operation. Consequently, it is normal for
the fan to start and stop during charging.
Overheat protection
The charger is designed to shut itself off if overheating
is detected. Once the charger cools down, it will resume
charging automatically.
BATTERY CHARGING TIME
The built-in intelligent microprocessor will continuously
monitor and adjust the charger to provide a fast, safe and
efficient charge. Note that battery charge times will vary
depending on several factors including:
1. Battery State: If a battery has been only slightly
discharged, it can be charged in less than a few
hours. This same battery could take up to 10 hours if
very discharged.
2. Battery Rating: A higher rated battery will take
longer to charge than a lower rated battery under
the same conditions. A battery is rated in ampere-
hours (Ah), reserve capacity (RC) and cold-cranking
amps (CCA).
3. Charge Rate: The charge rate is measured in amps.
A battery charged at a lower rate will take longer
than a battery charged at a higher rate. However,
smaller batteries can be easily damaged by charging
S
at a rate which is too high for the capacity of the
battery.
4. Temperature: Cold temperature will affect a
batteries ability to accept a charge. Charging in cold
temperatures will increase the amount of time
required to charge a battery.
Please consult the table to help you to choose the
charging rate
The current you choose
to charge the battery
2A
8A
12A
Note: If battery size is not unknown, charge at the 2amp
rate. DO NOT overcharge batteries

MAINTENANCE AND CARE

f Clean cords and clamps each time you are finished
using the charger. Wipe off any battery fluid or debris
that might have come in contact with the clamps to
prevent corrosion.
f Store the power and output cable neatly to prevent
damage.
f Occasional cleaning of the battery charger case with
a soft cloth will help protect the finish.
f Always unplug the charger when not in use.
f Keep the charger stored in a cool, dry place
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
ENGLISH • 33
The capacity of the
battery recommended
8Ah ~ 20Ah
32Ah ~ 80Ah
≥ 48Ah

Publicidad

Tabla de contenido
loading

Tabla de contenido