Fault Codes; Troubleshooting; Service Information - Black+Decker BC12 Manual De Instrucciones

34 • ENGLISH

FAULT CODES

CODE PROBLEM
The battery voltage is less than
10V after 10 minutes of charging.
F01
The battery voltage is still
less than 13V after multiple
reconditioning attempts.
F02
Charge voltage is too high.
F03
Charge current is too high.
The temperature of the charger
F04
is too high.
Maintenance mode change to
F05
Floating charging Mode
F06 Reverse polarity.

SERVICE INFORMATION

BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.
For more information about our authorized service centers and if you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest you, or visit us at www.BlackandDecker-la.com

TROUBLESHOOTING

POSSIBLE CAUSE
Maybe there is short circuit in the
battery.
A load may be connected to the
battery.
The battery is sulphated beyond
reconditioning.
Battery is 24V, not 12V.
A load may be connected to the
battery.
High ambient temperature.
The charge current is too low,
can't fully charge the battery
Maybe there is short circuit in the
battery.
The battery is used during
charging
The self-discharging current is
larger than the floating current.
The battery clamps are
incorrectly connected.
POSSIBLE SOLUTION
Go to a professional Lab to test
the battery.
Disconnect the load and attempt
to charge again.
Replace the battery.
Confirm that battery is 12V.
Disconnect the load and attempt
to charge again.
Ensure adequate ventilation. The
charger will resume charging
after cooling.
Select a higher charge rate.
Go to the specialist to check the
battery.
Disconnect the load.
Please select higher charging
rate charger.
Disconnect clamps and ensure
proper connection.